These adjuster nuts were machined from a 1010 carbon steel hex stock with a 5/8-18 thread inside. Powder-coating and anodizing are available as well.

RC Car rear dogbones machined out of titanium Ti-6AI-4V for the highest strength and lowest weight. Even complex and tough materials can be handled.

T-6061 Billet aluminum

Extruded, machined and anodized aluminum

Billet T-6061 Aluminum


Every material, even challenging ones such as 6061 aluminum and titanium are possible with our factories. The tightest tolerances are our specialty. Give us your most complicated design and let us show you what XDC Global can do for you!